minimum tire tread depth in ohio

By On June 1 2021 0 Comments On June 1 2021 0 Comments. In the United States tire tread depth is measured in 32nds of an inch.

Tire Tech Measuring Tire Tread Depth With A Coin Car 1

All tires shall have a minimum of one sixteenth of one inch depth of tread on the road surface.

. In Ohio state law mandates that all tires must have a minimum of one-sixteenth of one-inch depth of tread on the road surface OAC 45012-1-06. However the extensive ADAC research proved that the minimum legal tread depth only describes the tires margin of safety. A The tire is worn to two thirty-seconds of an inch tread.

Or b less than 15 millimeters 116 inches in fraction of tread depth remains. The lower the tread depth the more likely a car will hydroplane. A The tire is worn to two thirty-seconds of an inch tread depth or less on.

2 Unsafe used tire means a used tire to which any of the following criteria applies. The minimum tread depth necessary for the front tires to perform as intended is at least 432-inch or 318mm in all the major grooves on the front tires. There is no minimum tire tread depth and no reference to tire grooving in the code.

A As used in this section. As stated these numbers are the bare minimum which means that whenever your tread depth reaches 4. With wintersnow and light truck tires the tread is deeper because this depends on the tires tread type which is either the Highway Rib Highway All-Season Off-Road All-Terrain or Off-Road Maximum Traction.

Most states require a minimum tread depth of at least 232 of an inch. 2 Unsafe used tire means a used tire to which any of the following criteria applies. There is no national law governing minimum tread depth but 42 states consider 232 inch the minimum legal tread depth.

California and Idaho consider 132 the minimum and Arkansas Montana. Steer tires or any tire on the front wheels must have a minimum depth of tread of 432 of an inch. Rule 45012-1-06 Motor vehicle equipment standards for tires.

A As used in this section. Every other tire must have a minimum. Wheels Ohio does not cover wheels in its laws.

At Tire Source we know that 232 is the minimum tread depth for perfectly dry and arid conditions. 2 Unsafe used tire means a used tire to which any of the following criteria applies. A tire shall not be worn to the extent that in any two adjacent major grooves at three equally spaced intervals around the circumference of the tire a the tread wear indicators contact the road.

Most modern ties have wear indictors built into the tire that indicate when the tire tread has reached the 232 mark and should be replaced. 1 Passenger car has the same meaning as in section 4513021 of the Revised Code. 1 Multipurpose passenger vehicle passenger car and truck have the same meanings as in section 4513021 of the Revised Code.

For wet and snow conditions we recommend a minimum of 432 tread depth. The typical new tire used on automobiles is measured with 1032 to 1132 of tread depth. The fact that a leading consumer publication recommended minimum tread depth carries more weight than if we as the tire industry came out and said it.

New tires typically come with 1032 or 1132 tread depths and some truck SUV and winter tires may have deeper tread depths than other models. However remember that the useable. All tires shall be free of major bumps or bulges breaks thrown tread or any condition which would constitute an unsafe.

Minimum tread depth for steer tires. Tread depth for commercial vehicles is subject to federal and industry regulations. How to Measure Tread Depth Wet Snow Conditions.

Tires The only requirement for tires in Ohio is that they be in safe operating condition without any bulges or exposed cords. Motor vehicle equipment standards for tires. Ad Shop for Tires by Brand at Tire Rack.

It is common knowledge that the minimum legal tread depth for all passenger car tires in Europe is 16 mm. These are the numbers necessary for the tire to be functional in all possible environments. A The tire is worn to two thirty-seconds of an inch tread depth or less on any area of the tread.

We Make It Easy. Department of Transportation recommends replacing tires when they reach 232 and many states legally require. We frequently get rain and snow in Northeast Ohio however and often in sudden torrential downpours.

In wet conditions tires can completely lose contact with the road and skid also known as hydroplaning. For the Federal Motor Carrier Safety Administration FMCSA minimum tread depth for truck tires needs to meet 39375. For summer tires the remaining tread depth must be no less than 3 mm and for winter and all-season tires it must.

Several states require 432 tread depth on front steering wheels since tread depth directly affects controllability. 1 Multipurpose passenger vehicle passenger car and truck have the same meanings as in section 4513021 of the Revised Code. B The tire has any damage exposing the reinforcing plies of the.

How To Measure Tire Tread Depth Goodyear Tires